charger

The charger operates at 110A , allowing even large batteries to be charged quickly if a suitable power source is available. The battery current is converted to 230V alternating current by the built-in 48V sine wave voltage converter , which also allows it to be used with sensitive electrical devices. The 100A transfer switch enables a wide range of applications, even when connected to the grid. A VE.Bus port is installed, as are two COM ports, which allow the Quattro to be networked in a variety of ways.

Power Control and Power Assist

Configuration, control and monitoring

All settings can be changed in just a few minutes . The software is very quick to configure. Monitoring can be done both on-site and remotely. On-site, this can be done using a smartphone, tablet, or a Multi Control Panel. For remote monitoring, data can be viewed and saved free of charge on the Victron Remote Management website.

Key features at a glance

• 6500W continuous power and 16000W peak power, for 48V battery voltage
• Device combination of inverter with transfer switch and 110A battery charger
• delivers a 230V sine voltage and a clean 50Hz frequency
• 2 AC inputs with integrated transfer switch / 2 x 100 A maximum switchable current
• 2 AC outputs + 1x additional output which only allows the current to pass to the consumer when the AC input is active.
• VE.Bus communication port provides extensive networking, system integration, configuration and control options for Victron Multiplus devices.
• supports three-phase operation (3 identical units of the same model required)
• Multiplus devices can be connected in parallel, up to 6 devices can be connected in parallel and the system performance can thus be significantly increased if necessary
• 2x COM ports are available in addition to the VE.Bus port, meaning there are virtually no limits to system integration
• PowerControl function enables working with limited generator power as well as limited shore or mains power
• PowerAssist function enables “power boost” of generators and shore connection support when needed
• Can be used as a UPS solution for uninterruptible power supply, thanks to the integrated 100A transfer switch
• Can be used for grid-connected self-consumption systems that only draw power from the grid operator when the battery capacity is no longer sufficient or other programmable events have occurred
• 3 separately programmable relays
• Compatible with numerous Victron control and display panels
• very high efficiency and low self-consumption